12F614 - 3Ø Solid Dielectric Recloser, Bi-Directional
Revision 3
Dec 27, 2024
Notes:
- Min. 50 ft. pole required for installation on joint pole.
- New reclosers will include two control transformers and a transfer switch inside the control panel. Refer to Compatible Unit BA10B.
- Two wedge connectors per switch are required to install line tap switches. Appropriate wedge connector size is listed in Compatible Unit D0520.
- Important — disconnect and bypass switches must be accessible to a service truck.
- Telecom & System Protection will determine and assign the type of antenna to install. See table below:
| Compatible Unit | Description |
|---|---|
| J0401 | DA Omnidirectional Antenna Installation |
| J0402 | DA Yagi Antenna Installation |
| J0403 | DA 6db Omnidirectional Antenna Installation |
Note: Drill holes as required to obtain switch spacing shown above.
| Compatible Unit | Description | Quantity |
|---|---|---|
| C0550 | Tap Wire, Insul 4/0 Soft Drawn Copper | 86' |
| DB0211 | Recloser, 3Ø 14kV 630A NXSTS Solid Dielectric Bi-Directional | 1 |
| D0502 | Switch, 600A 15kV Disconnect Xarm Mount | 6 |
| D0520 | Switch, 600A 15kV Line Tap | 3 |
| F0230 | Riser, 3" PVC - Control Cable | 1 |
| I0103 | Insulator, Spool w/ Rack #2 | 1 |
| I0322 | Insulator, 15kV Polymer Suspension | 4 |
| I0329 | Insulator, 15kV Polymer Suspension | 1 |
| J04016 | DA Antenna Installation | 1 |
| N0110 | Plate, Cu Ground 288 in2 | 1 |
| R0302 | Capacitor Bank and Control & Protective Equipment Racks | 1 |
| R1115 | Split Bolt Assembly, Pole Top | 1 |
| R1801 | Bracket, Standoff with 12" T-Slot | 2 |
| R0634 | Bolt, Machine 5/8" x 20" | 2 |
| R0734 | Washer, Galv Double Coil Spring Lock 5/8” | 2 |
| R0744 | Washer, Galv Sq 3" Curved 13/16" Hole | 2 |
| R1801 | Bracket, Standoff with 12" T-Slot | 1 |
| T030* | Clamp, Straight Line | 6 |
| T0714 | Terminal, Comp Captive Bolt 4/0 kcmil AAC/CU | 18 |
| T0924 | Bar, Extension Terminal Single Tap | 15 |
| T0925 | Bar, Extension Terminal Double Tap | 3 |
| W0201 | Holder, Plastic 15kV OH Switch Number 21" x 4" | 2 |
| X0301D | Crossarm, 10' Double Tangent Fiberglass | 1 |
| Z0102 | Clamp, Hotline #2 Al 6-336.4 kcmil | 8 |
| Z069+ | Connector, Mini-Wedge | 1 |
| Z063* | Connector, Wedge | 12 |
| Z064* | Connector, Wedge | 6 |
| Z0701 | Connector, C-Crimp #4 to #4 | 2 |