I0451-4 - Conductor Insulating Covers
Revision 2
Mar 16, 2007
| Conductor | O.D. | Cover I.D. | Cover Compatible Unit |
|---|---|---|---|
| #4 Cu Bare Solid | 0.204” | 3/8" | I0451 |
| #4 Cu WP Solid | 0.264” | 3/8" | I0451 |
| #2 ACSR | 0.316” | 3/8" | I0451 |
| 3/0 AAC | 0.464” | 5/8" | I0452 |
| 4/0 Cu | 0.528” | 5/8" | I0452 |
| 336.4 kcmil AAC | 0.666” | 3/4" | I0453 |
| 795 kcmil AAC | 1.026" | 1-1/4" | I0454 |
| Compatible Unit | Description | ID | Qty | MID |
|---|---|---|---|---|
| I0451 | Cover, Conductor Insulating Grey Pre-Slit Flexible Elastomer | 3/8" (0.375") | 1 ft | 1001348 |
| I0452 | Cover, Conductor Insulating Grey Pre-Slit Flexible Elastomer | 5/8" (0.625") | 1 ft | 1001349 |
| I0453 | Cover, Conductor Insulating Grey Pre-Slit Flexible Elastomer | 3/4" (0.750") | 1 ft | 1001350 |
| I0454 | Cover, Conductor Insulating Grey Pre-Slit Flexible Elastomer | 1-1/4" (1.250") | 1 ft | 1001920 |
Notes:
- Conductor insulating covers protect against phase-to-phase and phase-to-ground wildlife contacts between energized jumpers, leads, equipment terminals and ground on 12470 Grounded Y/7200 volt distribution systems. The covers are pre-slit for field installation over conductors. They must be field cut to the needed length.
Refer to Compatible Unit Section C for conductor O.D.’s for conductor sizes not listed in the above table. - If it is necessary to hold covers in place, their ends should be secured by applying 2 or more wraps of silicone rubber tape (Compatible Unit I0456 - MID 819112) using minimum wrapping tension.